The Steca system includes a 5kW Steca inverter, 9kWh usable capacity Pylontech lithium batteries, and 5.7 kW Jinko solar panels. Choosing the best system package for your home might be challenging, though, with so many options available.ġ00 up Off-grid solar Australia thoroughly analyzed the four well-known off-grid solar system packages offered in Australia: Steca, Victron, Selectronic, and Sungrow, to assist you in making an informed choice. Off-grid solar systems are a growing popular option as more Australians want to reduce their reliance on the power grid and embrace sustainable energy options. The Utility meter indicates that it takes now around 1100 W (2500 W residential load - 1364 W supplied by PV) from the grid to supply the home total load.Which Off-Grid Solar System Package is Best for Australian Homes? With this voltage, 1364 W is extracted from the PV string which is the GMPP value. (4)Ět 0.7s, the MPPT controller has set the boost duty cycle at 0.58 generating a PV string voltage of 168 V. (3)Ět 0.4s, a duty cycle scan of 0.25 seconds is performed by the MPPT controller to find the GMPP point. As you can see on the PV curve characteristic, the system is operating at a local maximum power point but not at the global maximum power point. With this voltage, 920 W is extracted from the PV string. When steady-state is reached at 0.35s, the MPPT controller has set the boost duty cycle at 0.44, generating a PV string voltage of 225 V. (2)Ět 0.3s, a partial shading condition is created by reducing the irradiance on some PV modules. The Utility meter indicates that the system takes almost no power from the grid to supply the home total load.
The solar system generates 2400 Watts and the DC link is maintained at 400 volts with a small 120-Hz ripple due to the single-phase power extracted from the PV string. (1)Ět 0.25s, with a solar irradiance of 1000 W/m2 on all PV modules, steady state is reached. Run the simulation and observe the resulting signals on the various scopes. The inverter, the 2500 W residential load as well as the neighbors' load are connected to the 240V secondary winding. The transformer 240 volt secondary winding is center-tapped and the central neutral wire is grounded. The grid is modeled using a typical pole-mounted transformer and an ideal AC source of 14.4 kVrms. The controller uses a voltage regulator outer loop and a fast inner loop current regulator to generate the appropriate reference voltage (Vref) for the PWM generator controlling the full-bridge converter. The Inverter Controller: The inverter control maintain the DC link voltage at 400 V while keeping a unity power factor.
0 kommentar(er)
